Previous Page | Next Page Contents Glossary Index Preparing the Physical Environment >

Space Requirements - Duplex Models

The dimensions of the Duplex Printing System and the Buffer/Flipper Unit  1 , the optimum separation of the units, the service clearance around the allowable configurations of these units, and the power cable and channel cable locations are shown in Figure 10 and Figure 11 for Models ED1/ED2.

Notes:
  1. The minimum size for Channel Cable Access opening is 200 x 200 mm (approximately 8 x 8 in.).
Figure 10. Models ED1/ED2 Inline Configuration
This is an image that illustrates the inline configuration for Models ED1/ED2.
Figure 11. Models ED1/ED2 Left Angle Configuration
This is an image that illustrates the left angle configuration for Models ED1/ED2.

For the 'h' configuration, in which the printers are parallel, the IBM-supplied Buffer/Flipper Unit is placed next to Printer 1. The turnbar/flipper device supplied by the customer is placed next to Printer 2.

Figure 12. Models ED1/ED2 Duplex 'h' Configuration (Both Printers Facing the Same Direction)
This is an image that illustrates the duplex 'h' configuration (both printers facing the same direction) for Models ED1/ED2.